Devair DRD 400 Spécifications télécharger pdf (Page 16)

Start-Up Procedures

1) Remove the Oil Filler Plug, and ensure that there

is Oil in the Crankcase. Refer to the "Lubrication"

section in the pertinent Compressor Unit manual

for the proper type and level of Oil.

2) Replace the Oil Filler Plug, and tighten as

required. Refer to Compressor Unit manual.

3) Do a visual inspection of the Unit, and e n s u r e

that all Bolt heads are sufficiently tightened. This

must be done, as some fasteners may become

loose in transit.

4) Turn the Compressor 'On' momentarily by

positioning the Fused Disconnect in the 'On'

position. Ensure that the Flywheel is turning in

the correct direction. Pit Boss Units rotate only

one way. For Heavy Duty Units, see "Pump

Rotation" (page 10) in Unit manual.

6) After having run the Compressor Unit for 30

minutes, close the Ball Valve, and allow the unit

to reach maximum operating pressure. Ensure

that the Compressor shuts down at the pre-set

maximum pressure, and the head pressure is

released through either the front of the Pump (the

CPR) or at the Pressure Switch.

7) Check the Compressor and Piping Systems for

air leaks, and correct as required.

8) Stop the Compressor, and check the Oil level in

the Crankcase. Add Oil as required.

5) Open the Compressor's Ball Valve, and start the

Unit. Ensure that the air is escaping to

atmosphere. Allow the Unit to operate in this

fashion for approximately 30 minutes. This

lubricates the Pistons, Bearings, and all internal

surfaces.

Do not place any materials on or against the

Belt Guard, or the Compressor Unit as a whole.

Placing materials there will limit the cooling of

the Compressor, and could lead to premature

failure.

1. Please note that, under normal operating conditions, the Compressor Unit

will operate intermittently. The Unit starts/stops without warning.

2. Shut off all power to the Air Compressor Unit before attempting any repair

or maintenance.

On Compressors with 3 phase power, adjust

the wiring at the Motor terminals if the rotation

is incorrect. Refer to the wiring diagram on or in

the Motor terminal box.

Do not attempt to operate the Unit without first

checking whether there is Oil in the Pump. Add

Oil as required. Serious damage may result

from use, however limited, without Oil.

The following is a guideline which the Customer must follow in the correct initial start-up of their new Compressor

Unit. Please pay close attention to the various Notes, Cautions, and Warnings.

NOTE

During the first few days of operation, check the Unit periodically to ensure it is

running smoothly and the controls are operating properly. Should you notice any

areas of concern, contact your Devair Distributor or Authorized Service Centre.

NOTE

- 16 -

On-Site Electrics

What is involved in the ‘initial start-up’ of the Unit ?

Air Compressors

Information Bulletin IFB-01

March ‘07

For Sales & Service contact:

CENTRAIR Air Systems & Supplies 705-722-5747 [email protected] www.centrair.ca

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 25 26

Commentaires sur ces manuels

Pas de commentaire

Devair DRD 400 Spécifications Page 16

Commentaires sur ces manuels

Produits connexes et manuels pour Sèche-cheveux Devair DRD 400