Devair DRD 400 Spécifications télécharger pdf (Page 15)

Installation - Electrical

It is responsibility of the Compressor owner to ensure

that the Compressor Unit is electrically connected in a

safe and correct manner. Any electrical work should be

carried out by a competent Electrician, and be done is

such a way that it meets all applicable Codes and

Regulations.

A Magnetic Starter, as shown below, is not required on the

Pit Boss line of Units, but must be an integral part of the

Heavy Duty Cast Iron Compressor Unit circuit as it

provides overload protection to the Electric Motor. A

Magnetic Starter can be purchased separate from the Unit,

or factory-mounted at time of manufacture.

‘Figure 7’

Typical Pictoral Representation

of Compressor Installation

Failure to connect the Compressor

correctly to your building's electrical

services may result in serious personal

injury, or damage to equipment.

Pressure

Switch

Motor

L L 3

‘Figure 8’

Typical Magnetic Starter Wiring

(Subject to Local Codes & Authorities)

- 15 -

On-Site Electrics

How do I hook the Unit up to my building ?

Air Compressors

Main Fuse Box

Magnetic Starter

Fused Disconnect

or Circuit Breaker

Information Bulletin IFB-01

March ‘07

For Sales & Service contact:

CENTRAIR Air Systems & Supplies 705-722-5747 [email protected] www.centrair.ca

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 25 26

Pas de commentaire

Devair DRD 400 Spécifications Page 15